PEDDINGHAUS 210AD/13 66 TON IRONWORKER LARGE LOT OF PUNCHES & DIES

Description

THIS AUCTION IS FOR A PEDDINGHAUS 66 TON IRONWORKER WITH LARGE LOT OF PUNCHES & DIES.
$$PLEASE EMAIL rich at adealequipment dot com OR $2830$$ IF YOU HAVE ANY QUESTIONS or SHIPPING QUOTE$$
PEDDINGHAUS 210AD/13
S/N 529 B088
DESCRIPTION
Flat steel shears
Blade length: 10"
Flat steel up to: 4" x 3/4" / 9-1/2" x 3/8"
Sectional steel shears
angle iron up to: 4"x 4" x 1/2"
miter: 45° up to 3-1/2" x 3-1/2" x 5/16"
T-iron up to: 4"x 4" x 3/8"
Miter: 45° up to 3" x 3" x 3/8"
C channel 7"-14.75 lbs per/ft
I steel 6"- 12.75 lbs per/ft
Stroke rate: approx. 30 / min.
Steel bar shear
round steel up to: 1 5/8"
square steel up to: 1-1/2"
Notcher
plates up to: 1/2"
Notching width up to: 2"
Notching depth up to: 3-3/8"
Hole punch
throat: 14-1/2"
punching capacity: approx. 66 ton = 1" Ø x 5/8" / 13/16" Ø x 3/4"
drive power: 5 hp 230 volt 3 phase
weight: approx. 4850 lbs
Equipment
manual and foot release
Support table at the hole punch
Various additional tool holders
Comes with various punches & dies
3 die holders F-55 (1-13/16") , F-59 (2"), F-62 (2-3/8")
2 sets of punches F12 (BODY 1.032 DIA.) , F-26 (BODY 1.531 DIA.)
1 quick-change punch holder keyed with 4mm
1 quick-change locking nut
1 quick-change punch sleeve (only fits the F12 PUNCHES)
1 PUNCH STRIPPER PLATE
SPECIFICATION SUBJECT TO VERIFICATION
$$PLEASE EMAIL rich at adealequipment dot com OR $2830$$ IF YOU HAVE ANY QUESTIONS or SHIPPING QUOTE$$